Hydraulic hose assembly EN 853 2 SN, DN 6, M 12x1.5, pipe connection 6 L, DKO / CEL, 0.8 m, 315 bar

Type 2 SN to EN 853 joins two connection points over 0.8 m at DN 6 and 315 bar working pressure. Thread M 12x1.5 and pipe connection 6 L define the mating point. The reinforcement consists of two steel wire braids. The two ends carry different connection forms, so the assembly links two different mating points.

Benefits

• working pressure 315 bar at nominal size DN 6
• reinforcement of two steel wire braids to EN 853 2 SN
• temperature range -40 to +100 °C (briefly +120 °C)
• cut to 0.8 m and crimped at both ends, no assembly work of your own is needed
• cover resistant to ozone and weathering
• connecting thread M 12x1.5 for the pipe connection 6 L, DKO / CEL

Applications

Its place is on hydraulic power units in plant engineering, where the line runs between pump, valve block and cylinder. According to the data sheet hydraulic oils on a mineral oil basis, vacuum (max. -0.83 bar), water, lubricants and fuels are approved.

Standards and conformity

The hose is built to EN 853 as type 2 SN and reinforced with two steel wire braids.