Hydraulic hose assembly EN 853 2 SN, DN 25, M 36x2, pipe connection 28 L, DKO / CEL, 1.2 m, 165 bar

Type 2 SN to EN 853 joins two connection points over 1.2 m at DN 25 and 165 bar working pressure. Thread M 36x2 and pipe connection 28 L define the mating point. The reinforcement consists of two steel wire braids. The two ends carry different connection forms, so the assembly links two different mating points.

Benefits

• working pressure 165 bar at nominal size DN 25
• reinforcement of two steel wire braids to EN 853 2 SN
• temperature range -40 to +100 °C (briefly +120 °C)
• cut to 1.2 m and crimped at both ends, no assembly work of your own is needed
• cover resistant to ozone and weathering
• connecting thread M 36x2 for the pipe connection 28 L, DKO / CEL

Applications

Its place is on hydraulic power units in plant engineering, where the line runs between pump, valve block and cylinder. According to the data sheet hydraulic oils on a mineral oil basis, vacuum (max. -0.83 bar), water, lubricants and fuels are approved.

Standards and conformity

The hose is built to EN 853 as type 2 SN and reinforced with two steel wire braids.