Hydraulic hose assembly EN 853 2 SN, DN 16, M 26x1.5, pipe connection 18 L, DKO / CEL, 2.6 m

This version of type 2 SN to EN 853 is already cut to 2.6 m and crimped at both ends, so no assembly work is left to do. It carries DN 16 at 250 bar and connects through thread M 26x1.5 to the pipe connection 18 L. The build uses two steel wire braids. The two ends carry different connection forms, so the assembly links two different mating points.

Benefits

• working pressure 250 bar at nominal size DN 16
• reinforcement of two steel wire braids to EN 853 2 SN
• temperature range -40 to +100 °C (briefly +120 °C)
• cut to 2.6 m and crimped at both ends, no assembly work of your own is needed
• cover resistant to ozone and weathering
• connecting thread M 26x1.5 for the pipe connection 18 L, DKO / CEL

Applications

It is used on machine tools and presses, where the power unit and the consumer are joined over a pre-assembled length. According to the data sheet hydraulic oils on a mineral oil basis, vacuum (max. -0.83 bar), water, lubricants and fuels are approved.

Standards and conformity

The hose is built to EN 853 as type 2 SN and reinforced with two steel wire braids.