Fine filter, G 1", 1.5 - 16 bar, zinc die casting Z410, plastic bowl with protective cage

Where particles in the medium disturb the plant, the fine filter separates them reliably. The device is screwed in with G 1". The inlet pressure extends over 1.5 - 16 bar. The body is made of zinc die casting Z410. The temperature range extends over -10 to +60 °C.

Benefits

• Connection thread G 1" for direct installation in the line
• Temperature range -10 to +60 °C for use in the workshop and in the plant
• Flow rate 2000 l/min without any appreciable pressure drop in the line
• Condensate capacity up to 87 cm³ between two drains
• Height 248 mm and length 85 mm for installation planning
• Inlet pressure 1.5 - 16 bar as the leading rating of the device

Applications

Preparation of compressed air upstream of valves and cylinders, compressor stations, pipe networks and workshop supply.

Standards and conformity

The data sheets refer to Richtlinie 2014/34/EU. Further approvals are not documented and are therefore not stated.